A new generation AIO Flight control for FPV, based on F303 MCU, using F3 MCU controls OSD over SPI bus in DMA mode,

OSD Configation has been incl. in Betaflight GUI.

Supports SD Card and LIPO direct input (2-4S)

MPU6000 at SPI bus.

Pro Version using SBEC which makes less heat than LDO version(The Normal version)
Pro Version has build in Current Sensor and Power Filter too.

Specification:
STM32 F303 MCU, Runs Betaflight 3.0 firmware
SBUS/PPM input (Pinheaders)
8PWM output (1-4Pinheaders and Sh1.0 Plug, 5-6 as Pinheaders)
Only 36x36mm, mount holes 30.5x30.5mm
SPI Sensor MPU6000
SD Card solt
2-6S Lipo Direct power
5V3A SBEC
Build in Current sensor
TDK power filter for VTX and Camera

Package included:
1 x Omnibus F3 Pro V2 Flight Controller