KDS Innova 550E flew well with KDS EBAR system but I noticed some issues. Main rotor Shaft was bent and was causing vibrations and many of the screws were loose. Damn it. So I took few hours to pay attention to my beloved 550E. Replaced Bent main shaft, replaced both main and tail rotor blades, tightened screws with loctite and Reset the BeastX, this time real nicely. Results were sweet, I had fun doing 3D and seeing my beast back in action with beastX. This is flight 1, flight 2 will follow. Comments and feedback welcome at [email protected] , [email protected] or [email protected] Don't forget to visit , and Subscribe to