MinimOSD setup on MultiWii - Adding battery voltage readout
In this video we build on the first two videos that showed how to add a MinimOSD to a standard Multiwii flight controller.
In this video we look, step by step, of how to make, install, configure and tune a voltage sensor so you get an accurate voltage display in the heads up OSD (on screen display). We are using the firmware we uploaded in .
You will need a fine soldering iron and a steady hand to make this as it does require soldering onto the ATMEGA328 processor pin directly.
Thanks to all my subscribers who asked for this I hope it answers your questions!
Please LIKE and SUBSCRIBE.
Happy flying!
In this video we look, step by step, of how to make, install, configure and tune a voltage sensor so you get an accurate voltage display in the heads up OSD (on screen display). We are using the firmware we uploaded in .
You will need a fine soldering iron and a steady hand to make this as it does require soldering onto the ATMEGA328 processor pin directly.
Thanks to all my subscribers who asked for this I hope it answers your questions!
Please LIKE and SUBSCRIBE.
Happy flying!
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Watch more videos
-
Deathstroke 3d printed wearable mask #shorts
Deathstroke 3d printed wearable mask with X1C BambuLab #shorts #3dprinting #deathstroke #bamb... -
DeathStroke BambuLab X1C #Shorts
#shorts DeathStoke wearable mask made with BambuLab X1C #3dprinting -
#Shorts massive servo wire attack
About 200 packs and 1000 servo leads in free fall For many many many planes to build! #shorts ...
Advertising