DIY Mini Quadcopter w/ OpenPilot CC3D Wiring, Configuration, and Garage Maiden
3D files for mini quadcopter are here:
Build log is here:
I purchased my OpenPilot CC3D from here:
All I can say is from the little amount of time I've spend with the CC3D is that it's amazing. It handles incredibly well and I'm working on tuning my gains for acro flight. I'll post a video of that later.
The configuration wizard for the CC3D is very easy to use. This was my very first CC3D setup and configuration, and I didn't run into a single problem.
Build log is here:
I purchased my OpenPilot CC3D from here:
All I can say is from the little amount of time I've spend with the CC3D is that it's amazing. It handles incredibly well and I'm working on tuning my gains for acro flight. I'll post a video of that later.
The configuration wizard for the CC3D is very easy to use. This was my very first CC3D setup and configuration, and I didn't run into a single problem.
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Watch more videos
-
SnapMaker J1 IDEX 3d printer - double extruder workflow sample dual head print
#shorts Enjoy double extruder workflow satisfaction Music by: Gibran Alcocer - Idea 1 - piano c... -
DeathStroke BambuLab X1C #Shorts
#shorts DeathStoke wearable mask made with BambuLab X1C #3dprinting -
DLG - FLITZ - soaring joy!
The joy of DLG soaring! Pilot and Wing owner - Andrius Narbutas Bright LED: / - More products ...
Advertising