▼ ▼ ▼ SETUP LISTED BELOW ▼ ▼ ▼
Some Acro action with the K.Haring, finally i getting used to it.
Pushed the 850mAh Tattu to a flight time of 4min what is very good for this throttle aggressive flight.
The flight controller is now softmounted too.
Setup/Used parts:
K.Haring125 Frame: ( from Stand-in quad design / Vendor is Stefan van der Ende )
(NEW) /
20x20mm F3 Flight Controller with built in PDB " PICOBLX ": ( softmounted )
20x20mm 25-200mw VTX with OSD "Innova":
Micro 5.8G FPV VTX Antenna IPEX ( pigtail connector ) :
Racerstar BR1407 3500kv Brushless motors:
EMAX Bullet 12A BLHeli_S ESC "EMX-SC-1771":
Eachine Wizard 800TVL FPV cam (with GoPro Lens):
GoPro Lens with 170° FOV:
Flysky FS-A8S iBus Receiver:
Gemfan 3035 Quadblade props:
Tattu 4S 850mAh 75C Lipo with XT30 plug:
Weight without Lipo: 148.49g
Software Specs:
Betaflight 3.1.7 with stock PID's
Gyro Looptime: 8khz
PID's Looptime:8khz
ESC Protocol: Multishot 16kHz
RX Protocol: iBus
Lowpass Filter PT1
Other Parts:
Flysky i6X Transmitter ( i have the Flysky i6, without the X, but flashed it so it's basicially the same ):
2.4G 2W Radio Signal Booster:
Eachine VR D2 Pro Diversity FPV Goggles: ( with TBS Triumph + TBS Patch antenna )