This video shows some footage of the Caddx Turtle camera. (watch in 2K for best quality)
Get your Turtle here:
Iam really impressed about the video quality of this ~60$ camera!
Camera settings are stock on this video, only raised saturation about 15% to get a more vivid look and i really can't complain.
Nice wide dynamic range - no problems even when flying against the sun.
Seems to be also very jello resistent because i threw on this old hexa some used and beaten up 3052's because these were the only props i had left.
To avoid YouTube horrible FHD compression i upscaled the video to 2K on a VBR with 25-30 Mbps.
Setup of the Hexacopter from this video & other used parts:
VSA165 3" Hexacopter Frame : ( from Armattan Productions / Produced by Heng Ong)
Motors: Racerstar BR1407 3500KV:
Camera: Caddx Turtle
Receiver: Flysky A8S on iBus :
RX Antenna: 3dBi Dipole with UFL plug :
Propeller: Gemfan Flash 3052:
VTX Antenna: 7cm 2.5dBi-3dBi 5.8G 4-Leaf RHCP Micro Clover Antenna IPX UFL :
Battery: Tattu 4S 75C 850mAh :
ESC: Racerstar REV35 BLHeli_S 3-6S : EMAX Bullet 15A BLHeli_S ESC "EMX-SC-1772":
Flight Controller: PIKOBLX
VTX: (Piko) Innova V2
Other Parts:
Radio RC TX: Jumper T8SG V2.0 Plus :
FPV Goggles: Eachine VR D2 Pro :
VRX Antenna (1) UFOFPV Pagoda Antenna:
VRX Antenna (2) Menace Invader:
TX Antenna: VAS Folded Dipole :
Software Specs:
Betaflight 3.4.1
PID:
45/45/25
50/50/27
75/45
10% TPA
Gyro Looptime: 8khz
PID's Looptime:8khz
ESC Protocol: DSHOT600
Anti Gravity @5
Gyro Lowpass Filter PT1 (100Hz) + Dual DTerm Lowpass Filter (100Hz+200Hz) + Dynamic Filter , no static Gyro Notch
iTerm Rotation ON (default)
Throttle Boost : 2
iTerm Relax: Roll / Pitch
RC Filter: Auto interpolation + Filter ( all axis )
DTerm Setpoint Weight: 0
DTerm transition: 1
Rates: All axis @1000deg/sec / RP: 0.30 expo / Y: 0.15 expo
BLHeli changes: Timing: medium-high