▼ ▼ ▼ SETUP / SETTINGS LISTED BELOW ▼ ▼ ▼
Now this is what I wanted to see! Still snappy with GoPro on top.
The Gemfan Flash 3052 prop is a huge improvement over the dys 3045 in all ways, much more punch so there is also more hangtime and it feels a lot of more stable in the air, not so loose like before.
Amazing too see that grip in fast cornering, way more predictable on the throttle control.
No settings changed since the last flight except these new props :) .
Setup/Used parts:
K.Haring125 Frame: ( from Stand-in quad design / Vendor is Stefan van der Ende )
(NEW) /
20x20mm F3 Flight Controller with built in PDB " PICOBLX ": (softmounted)
20x20mm 25-200mw VTX with OSD "Innova":
Micro 5.8G FPV VTX Antenna IPEX ( pigtail connector ) :
Racerstar BR1407 3500kv Brushless motors:
EMAX Bullet 12A BLHeli_S ESC "EMX-SC-1771":
Runcam Swift 2 NTSC / 2.1mm lens
Flysky FS-A8S iBus Receiver:
RX Antenna: 3dBi Dipole with UFL plug :
Gemfan Flash 3052 3 Inch 3 Blade props:
Tattu 4S 850mAh 75C Lipo with XT30 plug:
GoPro Session (soft) TPU 30° Mount:
Weight without Lipo: 148.49g
Other parts i used:
TX Antenna: VAS Folded Dipole :
Radio RC TX: Jumper T8SG V2.0 Plus :
FPV Goggles: Eachine VR D2 Pro :
VRX Antenna (1) UFOFPV Pagoda Antenna:
VRX Antenna (2) Menace Invader:
HD camera: GoPro Hero 5 Session @ 1080p Superview
Software Specs:
Betaflight 3.3.1
PID:
40/50/30
60/60/35
80/55
DTerm Setpoint Weight: 0
DTerm transition: 1
TPA: 10% / 1650 threshold
Gyro Looptime: 8khz
PID's Looptime:8khz
ESC Protocol: Multishot 16kHz
RX Protocol: iBus
Anti Gravity @3
Lowpass Filter PT1 + Dynamic Filter , Both Gyro static notches turned off
3inch 3" 3052 fpv racer racing drone gopro action cam