Pixhawk 2 Alpha Test with Bixler 3 and ArduPlane 3.6 Firmware
I wanted to share my first experience with Pixhawk 2 and so far I've been very impressed. The Bixler 3 is a bit tight but I was able to get Pixhawk 2 mounted in the fuselage. In the video I manually take off, trim, switch to FBWA, switch to Loiter, and then land manually.
This test was done with ArduPlane 3.6 firmware. I'll be covering Pixhawk 2 in much more detail in an upcoming video. I'm very excited about this open source hardware and software platform.
A special thanks to Philip Rowse (www.proficnc.com) and Paul Dinardi (www.jestersdrones.com) for their support.
This test was done with ArduPlane 3.6 firmware. I'll be covering Pixhawk 2 in much more detail in an upcoming video. I'm very excited about this open source hardware and software platform.
A special thanks to Philip Rowse (www.proficnc.com) and Paul Dinardi (www.jestersdrones.com) for their support.
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Watch more videos
-
#DriftMolėtai "Street" drift race finals 2022
Happy drift day! Had a chance to be part of Moletai street drift race Finals! #DriftMolėtai grį... -
DLG - FLITZ - soaring joy!
The joy of DLG soaring! Pilot and Wing owner - Andrius Narbutas Bright LED: / - More products ... -
Deathstroke 3d printed wearable mask #shorts
Deathstroke 3d printed wearable mask with X1C BambuLab #shorts #3dprinting #deathstroke #bamb...
Advertising