This tutorial is a step by step building log of the Universal Multi-Module (UMM) for deviationTX compatible transmitters. This module coupled with last Nightly Build permits to control up to 4 different RF chips and by consequence a lot of new protocols. This video is focused on the Devo10 but only the positioning of the UMM for other transmitters is changing.
More info at :
and
DEVO10
BILL OF MATERIAL (BOM)
1) Multi-module PCB
2) ATtiny24A-PU
3) A7105-500
4) nRF24L01+PA+LNA
5) CC2500 + PA + LNA
6) Dupont wires male to female (compatible 2.54mm)
7) 2.54mm male/female pins single row
8) 2mm pins header male/female
9) Tiny electrical wire
10) Heat Shrink tubes
11) uFL to SMA x 2 (or to RP-SMA as you prefer)
12) RG316 coaxial with SMA connector
13) 2.4G antennas (connectors should correspond to your choice of connector)
or classic stick (dipole)
TOOLS :
1) Soldering iron
2) Third hand + Magnifier
3) DMM
4) USBasp (for devo 7E users for example)
This version is 3.3V/5V so you can use it in 3.3V position and flash the ATtiny even with pre-installed RF chips
5) Flux
SOFTWARES
1) AVRdude program (for Devo 7E) :
/
2) AVR.hex file
/
3) Devo programmers (Devo 8/10)
/