DAL Cyclone V3 T5050C Review
After more flight testing on these and reviewing footage, while they are good props, they will not be replacing the Gemfan 5152 for me. I just feel more locked in an confident with the GF versus these.
Because these are high pitch heavy props, they need a high torque motor (2306, 2207) 2300-2500kv to turn them properly. If your motors aren't up to it (or you want to save some amps), stick with the V2 version.
Cyclone V3 from PropCity $3 a set (ships from Florida) :
Gemfan 5152 :
Enjoyed the video? Perhaps consider supporting me on Patreon.
Gemfan 5152 Review :
Check me out on Instagram!
/
Because these are high pitch heavy props, they need a high torque motor (2306, 2207) 2300-2500kv to turn them properly. If your motors aren't up to it (or you want to save some amps), stick with the V2 version.
Cyclone V3 from PropCity $3 a set (ships from Florida) :
Gemfan 5152 :
Enjoyed the video? Perhaps consider supporting me on Patreon.
Gemfan 5152 Review :
Check me out on Instagram!
/
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Watch more videos
-
Deathstroke 3d printed wearable mask #shorts
Deathstroke 3d printed wearable mask with X1C BambuLab #shorts #3dprinting #deathstroke #bamb... -
Enduro Rally 2021 - Pabradė military base
Had a wonderful opportunity to be in a very dirty place on a badly rainy morning but with great a... -
DeathStroke BambuLab X1C #Shorts
#shorts DeathStoke wearable mask made with BambuLab X1C #3dprinting
Advertising