Build your own racing drone Part 3. ZMR250 DIY
/
Third and final part of the FPV Racing Drone 101 build. Learn tips and tricks on how to build your own FPV Racing Drone
00:17 - Connect the FPV system
01:41 - Install the top plate
01:58 - Install the RC antenna holder
02:35 - Configuring the flight controller
07:06 - Radio control calibration procedure
09:46 - Uploading pre-configured parameters
10:28 - Adjusting the flight modes
12:18 - Adjusting the board orientation
10 degrees Camera holder - 3D Object.
Preconfigured parameters for ZMR250.
ZMR250 DIY Kit :
FPV Camera + Transmitter combo:
Third and final part of the FPV Racing Drone 101 build. Learn tips and tricks on how to build your own FPV Racing Drone
00:17 - Connect the FPV system
01:41 - Install the top plate
01:58 - Install the RC antenna holder
02:35 - Configuring the flight controller
07:06 - Radio control calibration procedure
09:46 - Uploading pre-configured parameters
10:28 - Adjusting the flight modes
12:18 - Adjusting the board orientation
10 degrees Camera holder - 3D Object.
Preconfigured parameters for ZMR250.
ZMR250 DIY Kit :
FPV Camera + Transmitter combo:
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Watch more videos
-
DLG - FLITZ - soaring joy!
The joy of DLG soaring! Pilot and Wing owner - Andrius Narbutas Bright LED: / - More products ... -
Deathstroke 3d printed wearable mask #shorts
Deathstroke 3d printed wearable mask with X1C BambuLab #shorts #3dprinting #deathstroke #bamb... -
#Shorts massive servo wire attack
About 200 packs and 1000 servo leads in free fall For many many many planes to build! #shorts ...
Advertising