To see all of the videos in this series visit
This video was created after requests from subscribers.
This video series has been created for first time builders so they can understand where each piece of a build fits and follow each of the steps easily. However due to the complex nature of this setup I would recommend that you use the similar method for adding a Buzzer we covered earlier in the series if you are new to building and programming quad copters using the CC3D ()
Find the Buzzer on HobbyKing at ...
You can read up about the options for the PPM connection at
In this video we will over:
- Introduction (0:02)
- Demo of it working (0:28)
- How to wire up the buzzer and PPM/CPPM receiver (2:34)
- CPPM pin options (pin 3 or Pin 8) (3:08)
- Configuration in Openpilot (3:54)
- Setting up the Rcvrport (4:46)
- Setting up the input channels (6:21)
- Quick overview of TARANIS model setup (7:12)
- Setting up the output we want to use for the buzzer (8:31)
- Configure the PWN range of the output channel (10:03)
- Quick recap on steps (10:40)
- Summary and demo (11:23)
Thank you for watching, please LIKE and SUBSCRIBE.
Happy flying!