Setting up Buzzer for CC3D and BetaFlight
A lost alarm is very useful on a FPV racer. I did this with my Taranis X9D+ transmitter, D4R-II receiver in PPM mode, for my Eachine Racer 250 that comes with a CC3D board. I have flashed it with BetaFlight, which has BP6 support. Does not work for CleanFlight as special modifications to the firmware is needed to support Beeper at Pin 6.
Contents:
0:16 - Beeper modification
0:26 - FC cable modification
1:12 - BetaFlight settings
2:07 - Demonstration
Eachine Racer 250 from Banggood.com:
Music: Cruising Back in Time, by Eric Matyas
Contents:
0:16 - Beeper modification
0:26 - FC cable modification
1:12 - BetaFlight settings
2:07 - Demonstration
Eachine Racer 250 from Banggood.com:
Music: Cruising Back in Time, by Eric Matyas
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Watch more videos
-
Dirt bike and quadbike event at Crazy Ferma 2022-02-06
Another great winter event for dirt lovers. This time it was really bad weather, frozen fingers,... -
Enduro Rally 2021 - Pabradė military base
Had a wonderful opportunity to be in a very dirty place on a badly rainy morning but with great a... -
Deathstroke 3d printed wearable mask #shorts
Deathstroke 3d printed wearable mask with X1C BambuLab #shorts #3dprinting #deathstroke #bamb...
Advertising