Share the Hobby with Trainer Mode (aka Buddy Box) using Turnigy 9X Transmitters
I've been wanting to learn how to set this up for a while. I expected it to be more difficult than it is and wanted to share how to setup trainer mode with the Turnigy 9X transmitter. The trainer switch is backwards from what I'm used to. I previously did this with the DX5e and my buddy's DX6i so the Turnigy switch is opposite. Maybe there's a way to configure that but I haven't figured it out.
The quad in the video is my DIY Mini Quad which can download and 3D print from Thingiverse:
The quad in the video is my DIY Mini Quad which can download and 3D print from Thingiverse:
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Watch more videos
-
Auto moto parkas 2021-11-28 SandBOX
Auto moto parkas 2021-11-28 SandBOX Daugiau informacijos: / #sandbox #amp #moto --------------... -
DeathStroke BambuLab X1C #Shorts
#shorts DeathStoke wearable mask made with BambuLab X1C #3dprinting -
DLG - FLITZ - soaring joy!
The joy of DLG soaring! Pilot and Wing owner - Andrius Narbutas Bright LED: / - More products ...
Advertising