My review of the Quadrysteria QR 200! Join me while I build it and take it for it's first flight! The QR200 is designed differently then all the other racing quads out there, with vertical plates and a mount for a HD camera like a GoPro or Mobius. QR stands for "Quadrysteria Racer," and it has a wheelbase of 200mm. It is able to run 1806 thru 2206 motors with up to 5 inch propellers. When using 5 inch propellers, the blades pass inside the frame a small amount. Don't forget to try out 4 inch props on this quad, it really shines with them!
Hope you enjoy this video.
Product link for the QR 200:
I was sent a Complete Bundle for review. It consists of:
4 x SunnySky X2204S 2300kv Motors
4 x BLHeli 18amp Lite ZTW Spider ESCs
Acro Naze flight controller with buzzer
New Mini stackable PDB with two BECs and video pads
Set of 4 x 4.5" Quadrysteria Basher Bullnose props
Motor screws 16*M3x6mm
14AWG Wire with heat shrink (Battery lead)
20AWG Wire with heat shrink (ESCs)
I purchased the following components to finish the build:
Acro Naze Rev6 flight controller
Frsky X4R-SB receiver
HawkEye Mini 200mw Race Band VTX
HS1177 FPV camera
3D printable camera mount link:
I chose to try a Naze32 Rev6 in this quad to try out the FrSky SBUS receiver, and had plenty of problems with the Naze32 Rev 6... It is very buggy. My recommendation is to hold out for the next stable revision (Rev6A.)
I used oil based sharpie markers to highlight the edges of the frame with red, and I ran the power wires through paracord sheathing for a clean look. Simply cut a piece of paracord, remove the center strings, slide the wires through, and add heat shrink tubing to the ends to dress it up. I used 550 weight paracord since the wires are thin. If you have trouble sliding the wires through, a trick is to spray a little Windex or window cleaner on the wires for lubrication first (just clean it off before soldering, or powering anything up.)
PIDs used in Betaflight:
P Roll 5.5
P Pitch 8.3
P Yaw 10.4
I Roll 0.037
I Pitch 0.038
I Yaw 0.045
D Roll 29
D Pitch 29
D Yaw 0
TPA 0.25
TPA Breakpoint 1500
Check out my buddy Chase's channel here:
Intro screen music credit:
David Bulla - Highlife youtu.be/5H4XVwnrmo4
Build video music credit:
Codeko - Crest [NCS Release] youtu.be/iq1jqaK49SgU
First flight video music credit:
Disfigure - Blank [NCS Release] youtu.be/p7ZsBPK656s
Closing music credit:
Disfigure - Hollah! [NCS Release] youtu.be/m0ZXoiIZ40U
Please like and subscribe!