Dennis Baldwin - Channel
-
Quadcopter Back Loop How to with Blade mQX
The Blade mQX is a great starter quad: I've been wanting to do loops and rolls with my Naza and... -
EMLID Reach RTK Setup for Sending GPS Corrections from Base to Rover Over Wi-Fi
I continue to be amazed by these Reach RTK GPS modules: Configuration is very easy through the... -
Payload Dropper Proof of Concept for DroneBlocks and Drone Delivery
This concept stems from a DroneBlocks session where a student asked how to deliver medicine witho... -
RMRC Recruit V2 FPV Wing Build, Wiring, FrSky Taranis Config and Maiden
I'm really enjoying this little FPV wing and it's hard to beat for the money. At the time of this... -
How to Discharge and Dispose of LiPo Batteries
I had a Turnigy LiPo with a dead cell and wondered what to do with it. Instead of waiting for it ... -
FrSky Taranis Gimbal/Servo Custom Range Using Curves
This was a question from RedHotPheasant that I wanted to respond to by doing a video tutorial. It... -
Kickstarter Project for Canon Trigger Cable with CHDK and Pixhawk Based on GPS Distance
This video talks about a Kickstarter project in the making for a camera trigger cable, which will... -
Reach RTK GPS Long Range Setup w/ 915 MHz 3DR Radios
This video shows how to setup the EMLID Reach RTK GPS units for long range communication with 915... -
DJI Naza Quadcopter Getting Started and Running in Less Than 10 Minutes - Upgrade from KKMulticopter
I finally took the plunge and upgraded my KKmulticopter flight controller to the DJI Naza. I've b... -
DroidPlanner Mission w/ Tarot Hexacopter, Pixhawk, and Canon SX260 Running CHDK
This mission was done with DroidPlanner running on my Samsung Galaxy Tab 3, which you can find he... -
Naze32 Wiring, Configuration, and Garage Maiden with DIY Mini Quadcopter
This was my first-time experience with Naze32 and overall I'm very impressed. There are a couple ... -
DroneBlocks Android Beta for DJI/Ryze Tello - Intro to Drone Programming
If you'd like to program your Tello with DroneBlocks for Android then please join our beta here: ...
Advertising