Dennis Baldwin - Channel
-
Pixhawk/APM Field Tips for Auto Takeoff and Landing w/ APM:Plane Firmware
I wanted to share some tips on auto takeoff and landing that I've learned over the past few month... -
HobbyKing DIY Brushless Gimbal Motor Screw Sizes and 3D Printed Gimbal Update
If only HobbyKing would get there stuff together we'd know what size screws these motors take! He... -
Pixhawk Tips and Field Test with FBWA and RTL Flight Modes
I'm getting close to flying the 3D printed downward facing gimbal, but wanted to make sure the FX... -
3D Printed Downward Facing Gimbal Field Test w/ Pixhawk and FX79 Buffalo Delta Wing
Here is a link to the photos mentioned in the video: Keep in mind that all the photos you see ... -
3D Printed Downward Gimbal for Aerial Mapping
This is a current work in progress, but it's good enough to take up in the air and do some testin... -
Quick Update on 3D Printed Downward Facing Gimbal for Aerial Mapping
Thanks to everyone for your interest in this project. It's coming along well, but slower than I w... -
APM 2.5 In-Flight Pitch/Roll Gain Tuning for Stabilize Mode w/ TBS Discovery Quadcopter
This video shows how to do in-flight tuning of your stabilize mode P-gain for pitch and roll. Thi... -
KK2.0 Multicopter PI Gain Tuning for Beginners
This is the last video in a 3 part series of converting the AeroSky quadcopter from a MultiWii co... -
DroneKit Python Simple Autonomous Mission with Raspberry Pi and Pixhawk Hexacopter
Here is the DroneKit takeoff and land script referenced in the video: I've been really impress... -
DJI Naza Basic and Attitude Gain Settings for Pitch & Roll Using Turnigy 9X Control Knobs
Please check out for more discussions about multirotors. This video demonstrates the process fo... -
DJI Naza 3 Flight Modes (Attitude, Manual, and GPS) w/ Turnigy 9X Transmitter and 3 Position Switch
This video demonstrates how to use a Turnigy 9X transmitter and the 3 mode switch to control thre... -
DroneKit Python Autostart on Raspberry Pi & Pixhawk Hexacopter
Many have asked how to get DroneKit to run on Raspberry Pi without having to manually invoke a py...
Advertising