iforce2d - Channel
-
If your motors ever briefly cut out...
... land right away!! I think this might have been a barometer/filter error -
STorM32 + X-Cam A10 slip-ring gimbal test
RCGroups thread: About STorM32 NT About third IMU (German) -
DIY quadcopter frame vs jello, round 2
Winner: wind, vibration and broken props. rctestflight video: -
DIY mini CNC machine part 10 (spindle round three + easy cuts)
I must have watched more than 30 DIY CNC build videos/series on YouTube, and never saw anyone els... -
DIY mini CNC machine part 12 (new lead nuts + more cut tests)
The spindle interference problem seems to be fixed now. -
Arduino + nRF24L01 + quadcopter
It flies! Frame: Battery: Motor+ESC+prop: PDB: CC3D: Power cable: Arduino: Radio (in tran... -
FPV practice (ghost branch forest)
Just a raw video that was on my SD card. Sorry about the low light and the noise - I keep forgett... -
-
DIY mini CNC machine part 11 (spindle round four + more cut tests)
Noise problem finally fixed? Datulab Tech video: -
DIY mini CNC machine part 8 (spindle, round one)
Mains-powered mistakes are always the most exciting :) -
FPV blooper (dirted?)
Did I go too far behind the hill? It didn't seem like it but I can't think why else I would sudde... -
Advertising